If your washer fills with water then stops, it’s usually caused by a sensor issue, lid lock problem, or control board glitch.
Common Causes
- Lid lock malfunction
- Sensor issue
- Control board glitch
- Drain issue
- Overload
1. Check Lid Lock
Ensure it’s engaging properly.
2. Reset Washer
Unplug for 5 minutes.
3. Reduce Load Size
Avoid overloading.
4. Check Drain System
Make sure water can flow out.
5. Run Test Cycle
Confirm normal operation.
FAQ
Why does my washer stop after filling?
Usually due to lid lock or sensor problems.